ModelQGO20.000D27
Net weight900 g
ApplicationsSuitable for oxygen-trim retrofits or original equipment using the supported LMV52 and PLL52 platform in boilers, process heaters, and forced-draught burners firing natural gas H or light fuel oil EL. Installation planning must address sampling position, gas velocity, temperature limits, cable routing, leakage prevention, and calibration or commissioning procedures from the complete Siemens system documentation.
Key featuresThe exact D27 variant uses a 230 V AC supply with a tolerance of minus or plus 15 percent and 50 or 60 Hz frequency.; Its specified measurement range is 0.2 to 20.9 percent oxygen, covering normal combustion-control and ambient-air reference conditions.; The zirconium-dioxide cell is regulated near 700 degrees Celsius and the unit consumes up to 90 W during heating.; Maximum documented flue-gas temperature is 300 degrees Celsius, while the mounting flange must remain at or below 250 degrees Celsius.; The sensor requires an AGO20 sampling or collector assembly; recommended flue-gas velocity at the collector is 1 to 10 metres per second.
Oxygen range0.2 to 20.9% O₂
Mains frequency50/60 Hz ±6%
Cell temperature700 °C ±50 °C
Product categoryHeated zirconium-dioxide oxygen sensor for combustion flue-gas measurement and oxygen trim.
Operating voltageAC 230 V ±15%
Power consumption90 W maximum; approximately 35 W under normal control
Product dimensionsWidth 80 mm; height 80 mm; depth 244 mm
Required accessoryAGO20 collector
Measuring principleZirconium-dioxide oxygen cell
Degree of protectionIP40 when installed as specified
Maximum flue gas temperature300 °C