ModelA4021A1002
ApplicationsIntended for gas-fired power burners and other large-capacity gas firing installations, where according to EN 676 a valve proving system can be used as an alternative to combustion chamber pre-purge, and for installations with or without pre-purge above 1200 kW capacity.
Key featuresUses the pressure status principle with the gas line pressure; a low gas pressure switch, recommended C6058A, must be part of the installation.; Supply 220-240 Vac, 50 Hz; maximum power consumption 4.5 VA; test time 25 seconds per valve with a total test sequence of approximately 65 seconds.; On detecting a failing or leaking valve, enters non-volatile lock-out, generates an alarm and prevents burner start-up; allowed leak rate up to 0.1% of maximum flow.; Relay contact ratings: valve outputs 4 A, cos phi 0.7; vent output 1 A, cos phi 0.7; internal fuse 5 A slow maximum; external fusing 16 A slow maximum required.; Operating temperature -10 to +60 °C, storage -40 to +80 °C; humidity 0-95% RH non-condensing; enclosure IP40; weight 0.65 kg including the ZL030001 subbase.; Wirable for pre- or post-purge configurations and for intermittent or interrupted pilot and three-valve arrangements; design life over 10 years or 250,000 cycles.
Total test timeapprox. 65 s
Product categoryIndustrial combustion safety component - self-checking valve proving system (VPS) for gas burner valve trains
Protection classIP40
Operating voltage220-240 Vac, 50 Hz
Power consumptionmax 4.5 VA
Test time per valve25 s